Bio Sleek organic Treatment | Bio Sleek-Nano Lamination

Step By Step
BIO SLEEK TREATMENT

STEP 1:

1.1 Wash hair with the Nano Lamination Clarifying Shampoo as recommended for the best results. (Do not use conditioner)

1.2 Dry hair completely with a blow dryer.

STEP 2:

2.1 Application- Shake well before use. Begin by separating the hair into 4 sections.

Apply directly onto the hair ½ inches from the roots avoiding contact with the scalp, which may produce a tingly or itchy reaction to unknown allergies and sensitive skin, and comb hair thoroughly with a fine-toothed comb.

Repeat again until the entire head has been treated. Ensure that the solution is evenly distributed and that the entire head is saturated with the treatment.

2.2 Leave the treatment for 50 minutes under

heat followed by 10 minutes without heat (60 min total).

For thick, curly, or resistive curly hair leave for 80 minutes under

heat and 10 minutes without heat (90 min total).

60 MIN

60-90 MIN

90-120 MIN

STEP 3:

A: Completely (100%) rinse all of the treatment from the hair.

B: For pregnant clients or children under 12

Rinse with water to completely remove the treatment.

Then use Nano Lamination Treatment Care Shampoo to wash (yes, wash, not just rinse) the treatment product out of the hair.

Repeat, using the Nano Lamination Treatment Care Shampoo to wash hair a second time until the hair and scalp are completely clean.

For Damaged or dry hair apply a hair mask/Conditioner after shampooing, wait for 5 minutes, and rinse thoroughly, before using the flat iron.

STEP 4:

Dry the hair completely (100%)
Make sure the hair is completely dry, then Divide the hair into 4 sections to prepare the customer for the next and most important stage – straightening the hair with the flat iron in small sections.

Repeat the same section six (6) to ten (10) times until the hair is luxurious and silky.

How can I know when ironing a section is completed?

1. when hair looks maximum shine.

2. If the ends of the hair are curly, iron well.

3. If the ends are damaged, iron lightly only about 4-7 times, until the cuticle is closed and the hair has the desired nutrient shine

4. In case of badly damaged hair, without curl, lower the temperature by 1-2 levels, depending on hair condition.

Set the flat iron at 380-450 °F (193-230 °C)

FOR BEST RESULTS USE BABYLISS PRO 2091/2094

*BEFORE APPLYING THE COLOR, WAIT ABOUT 10 TO 20 MINUTES AFTER TREATMENT*
Then wash your hair with shampoo and apply hair coloring.